MT29F2G01ABBGDWB-IT:G

MT29F2G01ABBGDWB-IT:G serial peripheral interface (SPI) NAND is an SLC NAND flash memory device that provides a cost-effective non-volatile memory storage solution where pin count must be kept to a minimum. It is also an alternative solution to SPI NOR, offering superior write performance and cost per bit over SPI NOR. The hardware interface creates a low pin-count device with a standard pinout that remains the same from one density to another and supports future upgrades to higher densities without board redesign. New features include user-selectable internal ECC and first page auto-load on power-up. It has six signal lines plus VCC and ground (GND). The signal lines are SCK (serial clock), SI, SO (for command/response and data input/output), and control signals CS, HOLD#, WP#. This hardware interface creates a low pin-count device with a standard pinout that remains the same from one density to another, supporting future upgrades to higher densities without board redesign.

• Single-level cell (SLC) technology, 2Gb density
• Standard and extended SPI-compatible serial bus interface
• User-selectable internal ECC supported 8bits/512bytes
• Advanced features are read page cache mode, read unique ID, read parameter page
• Automatic device initialization after power-up
• Blocks 7:0 are valid when shipped from factory with ECC enabled
• Software write protection with lock register, hardware write protection to freeze BP bits
• OTP space: 10 pages one-time programmable NAND flash memory area
• Quality and reliability, endurance: 100,000 PROGRAM/ERASE cycles
• 8-pin U-PDFN package, industrial operating temperature range from -40°C to +85°C